Jeep Cherokee

This is your not so basic steering setup that uses 7/8" Heims with easier adjustment & much stronger tubing. The kit can be used over or under ...

NOTE: THE CUSTOM WIDTH MINIMUM DISTANCE CAN NOT BE LESS THAN 2 1/4 OD OR  MORE THAN 4" These are designed with an offset so you can pull them way b...

Before you take a look at this kit consider something... If you are using High Steer Arms, you should use the 7/8" kit; it is only $10 more an...

You will receive: 2 - spring under leaf spring plates for 2.5" springs 2 perches for 3", 3.25" or 3.5" axle tube and 2.5" wide 4 U-bolts 8" Long a...

Note: If you are buying this to build your own tie rod  the tubing will need to be cut down.   This is a very nice kit that takes the diameter of a...

These are the bolts you need for the Pumkin side of a D44 and are pretty much standard, The exception being that they are .625" (5/8) rolled thread...

This is the way to make your existing longarm or radius arm kit actually strong enough for trail use! Quite an easy swap but think it through, add ...

This is a Spring Hanger made for 2.75" Toyota FJ60 leaf springs. The springs are 2.75" wide but the bushings make for an overall ID of just over 3...

We have been manufacturing steering kits and components for many many years. Throughout that time we have been repeatedly asked to build a welded k...

INCLUDES: 2-Perches for one axle DIMENSIONS: Axle diameter: 3.0"/3.25"/3.5" Width: 2.5" After we started our Desert Racing products I saw an obvi...

You have been asking for these for a while and they're finally here - Front Frame Reinforcements for your Jeep XJ! Pair these up with our XJ Chassi...

Features Made from 1.5" x .250 wall DOM Steel Bends for clearance of most diff covers Works up to a 4" lift High Angle Drag Link TRE ES2027 7/8" w...

The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. Give your vehicle great traction and save some cash. Choose a S...

These are the section of a coil Spring setup that can be the hardest to make when fabbing on your own, so here you are! They are 5 1/2" or 4 1/2" i...

This is your not so basic steering setup that mocks the factory setup with easier adjustment & much stronger tubing. The kit can be used with s...

This gasket is designed for the Dana 35 differential cover

This gasket is designed for Dana 30 differential cover.

This is a pretty much standard U bolt made to fit a D44 axle. The exception being that they are .625" (5/8) Rolled Threads for extra strength and t...

This is a pretty much standard U bolt made to fit a D30/35 axle. The exception being that they are .625" (5/8) Rolled Threads for extra strength an...

XJ Steering Box Brace with sector shaft support, braces the sector shaft and clamps the steering box. This combination allows no play to be transf...