$43.64 USD
We made this 1/4" thick bracket with the factory size mounting hole to fit the upper clevite bushing on most factory TJ, LJ, XJ, and MJ Jeeps. To use this with a JK (2007-2015 Wrangler) that has a larger mounting hole, the bracket will have to be drilled out to match.
Related products

$329.31 USD
7/8" DIY Heim Steering Kit (55” Tubing)
This is your not so basic steering setup that uses 7/8" Heims with easier adjustment & much stronger tubing. The kit can be used over or under ...
View full details
$999.99 USD
$27.49 USD
The Cure! For Jeep (CJ, YJ, TJ & XJ)
This cure is for the OEM Jeep Y link steering and is designed around the OEM Jeep tie rod end. Use on any other steering kit is at your discretion....
View full details
from $59.99 USD
Shackle Hangers
NOTE: THE CUSTOM WIDTH MINIMUM DISTANCE CAN NOT BE LESS THAN 2 1/4 OD OR MORE THAN 4" These are designed with an offset so you can pull them way b...
View full details
$315.70 USD
3/4" Heim Steering Kit (55” Tubing)
Before you take a look at this kit consider something... If you are using High Steer Arms, you should use the 7/8" kit; it is only $10 more an...
View full details
$41.99 USD
Jeep 2.5" Spring U Bolt Plates
This U Bolt retention plate is made for Jeep 2.5" width Leaf Springs and due to the oval bolt holes it will fit an axle from 2.5 to 4" in diameter,...
View full details